I would also expect the issue is a spill over. Often there is an obscure line that hides just under (above or below) a header/footer/detail section dividing bar. The way to find it when you think all your controls are far enough over to the left is to click-drag an area just to the right of you right-most control, over all the sections. If you have no room for that, you can temporarily widen the report in design view and try again. If anything is 'captured' it will be discovered. If you have no lines in your report, then save that tip for another day.
Last edited by Micron; 03-12-2018 at 08:05 PM.
Reason: spelin, gramur or punkchooayshun
The more we hear silence, the more we begin to think about our value in this universe.
Paraphrase of Professor Brian Cox.