brother ql-710w label printer

[merlin2049er]

Hi, I just picked one of these up and trying to get it to print out our labels (that had been printing on avery labels).



I set the printer to use 62mm x29mm labels in portrait , page is setup the same
using 3 columns across, 0" row spacing, 0" column spacing.

Funny thing is it print previews ok (a label on every page), but the label printer prints 1 label, followed by a blank label, and then repeats (prints 1 label, followed by a blank label).

I'm not sure if it's a brother label printer issue or a access reports issue?

Any suggestions?
Thanks,
Joe

[ranman256]

make sure there is not a pagebreak character in the report.
check the printer settings (in the report) to see if it is set to eject after each page.

[merlin2049er]

Thanks. The funny thing is it works with the larger labels. These small address labels are similar in size to the avery and that's been the issue.

[merlin2049er]

Actually, I just printed 5 labels, print preview worked fine.
It 3 actual labels and missed 2 labels - (blank labels) no extra labels, but nothing printed.