Remove Margin from a Pop Out Report

[95DSM]

I have a report that is being a pain. I have already made sure that the "Show Page Margins" is set as No. But I still get the bottom margin. Is there a way to remove the bottom margin or at least set the color (That way I could make it blend in)?

Please see attached pic to see what I am talking about.


Thanks,
95DSM

[weekend00]

setup the page, reduce the height.

[95DSM]

setup the page, reduce the height.

There's on a "Width" adjustment on the form, not a Height. Is there a way to change the margin color when the report is in "Report View"?

[95DSM]

All right I have noticed a difference when I change the Size of the acutal Access application.

-See right now my report is set to pop up.
-If I shrink the size of the actual Access application to smaller than what the pop out Report is in Design view, everything fits nicely. But if I Maximize the main Access application the pop out report, when in report view, has the large margin on the bottom. Its matching the size of the open area on the main Access application. Does this help you help me? Because its not helping me help myself.

[weekend00]

if you want the margin color the same as the report's backcolor, you may try to design the report in a very height size so that the report is high enough to cover the application area even when maximize.

[ConneXionLost]

There's on a "Width" adjustment on the form, not a Height.

While the report itself only has a width adjustment, each section within the report has it's own height adjustment. Have you checked the heights for each section?

[95DSM]

While the report itself only has a width adjustment, each section within the report has it's own height adjustment. Have you checked the heights for each section?

Yes, all of the sections (header, footer, detail, etc.) are appropriately measured.

Its just wierd that a pop up form can keep its original shape when accessed, but the pop out reports adjust to the size of the actual Access application. So if the main application is Maximized, the pop out report will match the size of the main application. But if the main application isn't maximised and at a smaller size, the pop out report will take its shape. And in this case, everything works fine.

Very frustrating. I'm assuming this is a mistake on Access's part? I dont know...

[ConneXionLost]

Do you have the "Auto Resize" property turned on or off?

[95DSM]

Do you have the "Auto Resize" property turned on or off?

I have it turned on.

[ConneXionLost]

Try turning it off, then resize the report window and save your changes.