Hello folks,
I have a form which contains a sub-form....
If I filter or do a find request on the Master form, Access finds or filters the record/s that I'm looking for.... So far, so good.... However, the sub-form doesn't re-fresh and the records are not displayed/remain blank.
When the Master Form/Sub-form go into this state, the sub-form remains blank even if I remove the filter..... I have to close the form and re-open to see the sub-form records/data again....
Oddly, if I go to "Design mode" and then immediately click back to "Form mode", the sub-form refreshes fine.
Can someone tell me the technique/switch/property I need to tweak in order to get the sub-form to update immediately after a filter or find request !
Thanks