How can I set warnings to false in the macro editor?
How can I set warnings to false in the macro editor?
Found this:
Use a macro to turn the messages off and back on
- In the drop-down list at the top of the Macro Builder, select the SetWarnings action.
- If you do not see the SetWarnings action listed, on the Design tab, in the Show/Hide group, make sure Show All Actions is selected.
- Under the SetWarnings action, click the arrow next to Warnings On and select No.
- Enter the necessary macro actions to perform the tasks that you want done with confirmation messages turned off.
- Below the last task action, select the SetWarnings action, then click the arrow next to the Warnings On and select Yes.
- Close the Macro Builder, save the macro, and then save the form.
Thank you - exactly what I was looking for
What action were you performing that needed the Warnings turned off? I think of that like unscrewing your "Low Oil" bulb.